1832387 Members
2894 Online
110041 Solutions
New Discussion

Re: The disk light is green but its not visible in the Commandview

 
Faizer Jameel
Frequent Advisor

The disk light is green but its not visible in the Commandview

Hi All
I have a va7410. In the Master disk array [ conroller unit] I have a disk that is is not visible in the commandview or using the armdsp command. The disk lightis green but its not blinking. I replaced it thinking its a fault. Still the disk has not been identified.
The array status indicates good.
any idea.
Thanks
faizer
3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: The disk light is green but its not visible in the Commandview

Please post a

# armdsp -a

What is the slot of the questionable disk?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: The disk light is green but its not visible in the Commandview

Connect to serial port on controller and check disk status, armdsp -d
Torsten.
Acclaimed Contributor

Re: The disk light is green but its not visible in the Commandview

The serial command is

# vfpdsp -d

or just

# dsp -d

but "armdsp -a" issued from the OS gives much more informaion.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!