64-bit support

[Isaac_4]

I?want know if the product
J3515A is supported in hp-ux 11.00 at 64 bit

[harry d brown jr]

I'm using them in my K-class servers running hpux 11i, so I'd say yes they work fine in 64bit mode.

[Michael Tully]

Check out the following post about this:

http://forums.itrc.hp.com/cm/QuestionAnswer/1,1150,0xc8940559ff7cd4118fef0090279cd0f9,00.html

Some of the patches listed may be old, so be aware of this.

[harry d brown jr]

issac,

Sorry, I was thinking of the J3514A (K-class), but I found this info on 11i (which is 64bit):

Pre-installed networking and I/O cards
The following networking, I/O, and mass storage cards will have their drivers pre-installed with (or built into) the HP-UX 11i Base Operating Environment:
HSC 10/100Base-TX card J3515A 1-port for workstations and D-Class servers

http://devresource.hp.com/STK/impacts/i677.html

[Angus Crome · Accepted solution]

The real problem with lack of support for hardware in 11 and 11i 64-bit is that they haven't ported any of the EISA drivers (and they aren't going to).
The card you are refering to is HSC/PCI and therefore 64-bit capable. I am using that same card in a D370 at 64-bit and it works fine.