HPE Community
HPE Aruba Networking & ProVision-based
1832276 Members
1823 Online
110041 Solutions
New Discussion

Re: check from the command line which port has max network traffic

 
'chris'
Super Advisor

‎11-09-2013 06:34 AM - edited ‎11-09-2013 06:37 AM

‎11-09-2013 06:34 AM - edited ‎11-09-2013 06:37 AM

check from the command line which port has max network traffic

hi

 

We have set up HP Switch e5412zl(j8698a) as a default gateway.
Howto check from the command line which port of HP Switch e5412zl(j8698a) has max traffic and paralyzes the whole network on this switch?

 

BTW is it possible to configure an alert for high port utilization?

0 Kudos
1 REPLY 1
Vince_Whirlwind
Trusted Contributor

‎11-10-2013 02:39 PM

‎11-10-2013 02:39 PM

Re: check from the command line which port has max network traffic

"show int port"

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.