- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- HPE Aruba Networking & ProVision-based
- >
- HP 2920-24G PoE Switch
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-16-2014 08:28 AM - last edited on 12-16-2014 05:33 PM by Maiko-I
12-16-2014 08:28 AM - last edited on 12-16-2014 05:33 PM by Maiko-I
HP 2920-24G PoE Switch
Q. My PoE switch is showing a fault blinking amber? It was installed with the power suppy cord in a non-surge
protected unit. We have had several power surges in the building. could it be shot? Tried to unplug and re-power switch
but, after initial sequence fault shows up. Please, Help!
P.S. This thread has been moevd from Community Feedback & Suggestions to ProCurve / ProVision-Based. - Hp Forum Moderator