ProCurve Switch 4208vl ,Gateway not accessable, Plz help.

[K-KHURSHID]

Startup configuration:

; J8773A Configuration Editor; Created on release #L.11.20

hostname "CoreHP"
snmp-server contact "M Khurram Khurshid"
snmp-server location "SKP Server Room"
module 1 type J9033A
module 2 type J9033A
module 7 type J9033A
module 8 type J9033A
interface G21
   name "Dispatch"
exit
interface H23
   name "HiTech"
exit
ip default-gateway 10.3.1.1
ip routing
snmp-server community "public" Unrestricted
vlan 1
   name "DEFAULT_VLAN"
   untagged A1-A24,B1-B24,G1-G20,H1-H24
   ip address 10.3.1.90 255.255.255.0
   no untagged G21-G24
   exit
vlan 2
   name "500K"
   untagged G21-G24
   ip address 10.3.2.1 255.255.255.0
   exit
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-HDx sensitivity high
fault-finder duplex-mismatch-FDx sensitivity high
ip route 0.0.0.0 0.0.0.0 10.3.1.1
spanning-tree
password manager

CoreHP(config)# ping 10.3.2.1
10.3.2.1 is alive, time = 1 ms
CoreHP(config)# ping 10.3.1.1
Request timed out.
CoreHP(config)#

systems on default vlan can ping gateway and able to access WAN services but systems on VLAN2 cannot ping or route to gateway and unable to access WAN services