HPE SimpliVity : Host Storage Network issue

[Patai]

Hello all,

It's me again. 

I have issu with storage network;

Maybe I have a problem with the wiring; the 1rst deployment is done, but failed for the 2nd.

If anybody can share stokage wiring diagram or storage switch config....

Thanks in advance.

Best regards 

[Vivekem]

Hi,

Please find below document

https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00039816en_us

Hope this helps

[Moderator edit: Removed the broken link. Please refer to https://support.hpe.com/]

[MikeSeden]

Patel,

Here is a standard vSwitch configuration-

[B0ris]

If you have "Switch connected" configuration, please check if you have configured Jumbo Frames (MTU 9000) on Storage & Federation ports on the network switch. It is most likely causing the problem.

[Patai]

Hello all,

This is my diagramm:

2 HPE switch + 1 HPE DL380 G9 / rack

@B0ris

Yes i have configured jumbo

[B0ris]

Do you have separated VLANs for Storage AND Federation network, or do you have one VLAN for both, and different IP subnet for Storage and Federation Network ?

[Patai]

Hi B0ris,

I have one Vlan (Vlan172) and diferent IP ( 172.18.x.x for Storage) and  (172..19.x.x for Federation)

Best regard

[MikeSeden]

What is your vSwich configuration? Does it follow that diagram? Are they standard vSwitches?

[Patai]

Hi MikeSeden
Yes, i use standard Vswitch
BR

[Gaisu]

Hello @Patai,

The best practice is to use 3 different vlans while deploying SimpliVity Management, Storage and Federation. Also you should enable Jumbo Frames (MTU 9000) on Storge and Federation vlans. Also if you have any rules blocking ports you should refer to SimpliVity site readiness checklist.

One done, reset the discovery state of your node and re-run the test.

[sinanosman]

I have the same problem. I will share how it went when I figured it out.