LAN Routing
cancel
Showing results for 
Search instead for 
Did you mean: 

HPE 1920 (JG925A) inter vlan routing not working

 
Highlighted
New Member

HPE 1920 (JG925A) inter vlan routing not working

Hi All,

I'm unable to establish inter vlan communication. Here is what I did:

1. Created 2 vlan: VLAN1 and VLAN2

2. Created interface for both VLAN:

  - VLAN 1: 192.168.1.1

  - VLAN 2: 192.168.2.1

3. Created access ports for VLAN 2

The problem is I can't even ping the interface from the other VLAN. For example, if im in VLAN 1, I'm unable to ping 192.168.2.1 and vice versa.

Is there a special way to switch on layer 3 mode of this switch? I did make this configuration work using a cisco switch. Please assist.

 

Thanks,

UAZ

1 REPLY 1
Highlighted

Re: HPE 1920 (JG925A) inter vlan routing not working

Hello,

The VLAN IP interfaces of the switch will transition to UP state only if they have physical member ports and at least one physical member port is UP. That means if you have a PC in VLAN 1 and you are trying to ping the switch IP of VLAN 2, you need to have an active port in VLAN 2. Otherwise VLAN 2 IP interface will be down and you cannot ping it.

A better test would be if you connect 2 end devices to both VLANs and test between them.  A host with IP in range 192.168.1.0/24 connected to an access port in VLAN 1. Default gateway should be 192.168.1.1. Another host connected to an access port in VLAN 2, with IP in range 192.168.2.0/24 and default gateway 192.168.2.1. This way both VLANs will be up and both hosts should be able to ping each other and ping the switch IP addresses.

I am an HPE employee

Accept or Kudo