Getting Driver_Power_State_Failure when restarting NetServer LC3 Server

[Dan Hernandez]

Upon restarting NetServer LC3 Server, I get a blue screen stating, that there was a Driver_Power_State_Failure. The message recommends disabling the bios memory options such as caching and shadowing. I've done this with the same results.

Upon getting the error, I have to do a cold boot.

I'm running Win2K server with 4.06.38PQ bios

Any ideas?

regards,
Dan

[amhakassa]

Hi Dan,

This is an Operating system issue as explained in the following microsoft articles.
Article - 239415
Article - 246243
Article - 821285

Therefore, you can look at those articles in Microsoft Knoledge base and pick the once that most probabily explain your issue and act as the article recommend

Regards
Amha Kassa

[Dan Hernandez]

Thanks, I'll look there.

regards,
Dan