netserver LH6000 R

[jennifer bogut]

On a netserver LH6000 R, what is the setting to have the server automatically start after a power failure, w/o having to press the button

[Theo Hill_1]

This isn't an available option.

[Greg Carlson]

Jennifer,

You need to look at your UPS for that feature.. The LH6000r will do an AutoServer Reboot if it should hang or hardlock. As Theo stated there isn't a auto power on setting for if power is lost however. What UPS do you use?

Look at this link:

http://www.jetcafe.org/~npc/doc/ups-faq.html

02.06
In addition, some UPS or UPS/software combinations provide the following functions:
Automatic shutdown of equipment during long power outages.
Monitoring and logging of the status of the power supply.
Display the Voltage/Current draw of the equipment.
Restart equipment after a long power outage.
Display the voltage currently on the line.
Provide alarms on certain error conditions.
Provide short circuit protection.

Ciao,
Greg

[Raymond A. Meijer]

I want to use 2 LH6000r servers in a cluster configuration with 2 APC MasterSwitches.

So it's not possible for these machines to boot automatically after having been switched off by the MasterSwitch?

What I want is that when one of the 2 machines goes down, the remaining machine will switch the offending machine's power off and back on to force a reboot...

[Raymond A. Meijer]

I installed Heartbeat/STONITH on these 2 servers and tested the configuration.

I found that server A stayed powered off after the server B killed it through the APC Masterswitch, but the server B did power on en reboot after server A killed it!

Any ideas?

[Raymond A. Meijer]

I tested STONITH yesterday and host A stayed powered off after it was killed by host B while host B did reboot after it was killed by host A!

Any ideas?!