Operating System - HP-UX
1836590 Members
2779 Online
110102 Solutions
New Discussion

Re: Accessing GSP leds status in HP-UX command-line

 
SOLVED
Go to solution
Pedro Simões
Occasional Contributor

Accessing GSP leds status in HP-UX command-line

Hi!

I need to access GSP leds status in HP-UX command-line. Is it possible? Which command should I use?!

Regards,
Pedro
2 REPLIES 2
Denver Osborn
Honored Contributor
Solution

Re: Accessing GSP leds status in HP-UX command-line

Have a look at this post, it should get you what you need.

http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=24689

-Denver
RAC_1
Honored Contributor

Re: Accessing GSP leds status in HP-UX command-line

NO you can not.

You will have to use VFP command from gsp.

You can access GSP logs from commandline. With cclogview command.

You can connect to GSP from commandline(Supported on old versions. then it was possible but not anymore.)
There is no substitute to HARDWORK