HPE Community
Operating System - HP-UX
1833625 Members
3537 Online
110062 Solutions
New Discussion

Accessing GSP leds status in HP-UX command-line

 
SOLVED
Go to solution
Pedro Simões
Occasional Contributor

‎10-20-2003 09:19 PM

‎10-20-2003 09:19 PM

Accessing GSP leds status in HP-UX command-line

Hi!

I need to access GSP leds status in HP-UX command-line. Is it possible? Which command should I use?!

Regards,
Pedro
0 Kudos
Reply
2 REPLIES 2
Denver Osborn
Honored Contributor

‎10-20-2003 09:47 PM

‎10-20-2003 09:47 PM

Solution

Re: Accessing GSP leds status in HP-UX command-line

Have a look at this post, it should get you what you need.

http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=24689

-Denver
Reply
RAC_1
Honored Contributor

‎10-20-2003 10:00 PM

‎10-20-2003 10:00 PM

Re: Accessing GSP leds status in HP-UX command-line

NO you can not.

You will have to use VFP command from gsp.

You can access GSP logs from commandline. With cclogview command.

You can connect to GSP from commandline(Supported on old versions. then it was possible but not anymore.)
There is no substitute to HARDWORK
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.