HPE Community
Operating System - HP-UX
1846054 Members
2298 Online
110253 Solutions
New Discussion

fcmsutil command

 
yc_2
Regular Advisor

‎07-02-2002 01:07 AM

‎07-02-2002 01:07 AM

fcmsutil command

Hi,

The output of the fcmsutil command for Topology of the HBA card is "IN_PRIVATE_LOOP".

How to change it to "PTTOPT_FABRIC"


Thanks in advance,
YC
0 Kudos
Reply
2 REPLIES 2
Stefan Farrelly
Honored Contributor

‎07-02-2002 01:16 AM

‎07-02-2002 01:16 AM

Re: fcmsutil command

You cant change it from the HP-UX end, the card autodetects the configuration depending on the port on the fabric switch/hub its plugged into - that needs configuring. Once its changed the HP will autodetect and change to PTTOPT_FABRIC.
Im from Palmerston North, New Zealand, but somehow ended up in London...
0 Kudos
Reply
Michael Tully
Honored Contributor

‎07-02-2002 01:29 AM

‎07-02-2002 01:29 AM

Re: fcmsutil command

Hi,

You need to make sure that the port your connecting to is actually set up as 'fabric'. in your switch. If your port in the switch is already set this way reset the card within 'fcmsutil'.
Anyone for a Mutiny ?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.