HPE Community
Operating System - HP-UX
1833996 Members
2160 Online
110063 Solutions
New Discussion

installing CiscoWorks2000 in a MC/ServiceGuard environment

 
Joseph Belesi
Occasional Contributor

‎05-15-2001 04:41 AM

‎05-15-2001 04:41 AM

installing CiscoWorks2000 in a MC/ServiceGuard environment

Looking for advice regarding the installation of CiscoWorks2000 in a MC/ServiceGuard environment (HP-UX 11.0). Does anyone have any "lessons learned" that they can share?

Thanks in advance...
0 Kudos
Reply
1 REPLY 1
Pedro Sousa
Honored Contributor

‎05-15-2001 06:48 AM

‎05-15-2001 06:48 AM

Re: installing CiscoWorks2000 in a MC/ServiceGuard environment

Hi Joseph!
I have CiscoWorks2000 installed on a stand-alone system. It is a very powerful tool, but it is heavy for the system too.
So, I do not have SG mixed with Cisco, but I would try it if I were you.
One thing, don't forget to change your NODE_TIMEOUT parameter to more than 5 seconds.
"EXPLANATION
ServiceGuard nodes periodically send a heartbeat (HB) packet to each other to prevent each other from reforming a cluster and adopting dead packages to another server.

If a server is heavily loaded, kernel processing takes priority over heartbeat generation and transmission."

good luck.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.