Operating System - Linux
1833032 Members
2510 Online
110049 Solutions
New Discussion

Re: NIC Card works only with Cross cable

 
Rejionline
Occasional Contributor

NIC Card works only with Cross cable

Hi all
I have a pc with 2 NIC cards of 3com(3c59x).I am able to configure both the NIC cards,once after reboot the configuration,ipaddress it shows.But I won't be able conncet or ping to any of the NIC,s through straight cable.I am using a switch.
'mii-tool' will say "no link".If I connect a cross cable the network will start working.

could any body can give suggestions on this.

regards
reji
6 REPLIES 6
Alexander Chuzhoy
Honored Contributor

Re: NIC Card works only with Cross cable

3c590 is a 10MB card. If the switch is 100MB (and not 10/100MB) then it won't work with a 10MB card.
Regards.
Steven E. Protter
Exalted Contributor

Re: NIC Card works only with Cross cable

Shalom,

Its still possible to find 10 BaseT hubs out there in resale shops and such.

If you have a cisco switch, have it configured for 10 BaseT manual.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Rejionline
Occasional Contributor

Re: NIC Card works only with Cross cable

hai alex

my switch is an hp switch.
Georg Tresselt
Honored Contributor

Re: NIC Card works only with Cross cable

>>> If I connect a cross cable the network will start working. <<<

Looks to me like something is badly wired either in your NIC or your hub. Try to connect your PC to another hub.
http://www.tresselt.eu
rick jones
Honored Contributor

Re: NIC Card works only with Cross cable

Back-to-back connections between NICs requires a cross-over cable _unless_ the NICs are Gigabit Ethernet. Those are the only ones where "Auto MDIX" support is mandatory per the specification. It is optional for 100BT and I'm not even sure it exists for 10BT.

If you want to connect two systems and do not have Gigabit cards, or a cross-over cable, you must use either a switch or a hub.

Similarly, if you want to connect two _switches_ (iirc or hubs or a hub to a switch) back-to-back prior to Gigabit Ethernet you need a cross-over cable unless one or the other has (Auto)MDIX support.

there is no rest for the wicked yet the virtuous have no pillows
Vitaly Karasik_1
Honored Contributor

Re: NIC Card works only with Cross cable

it may be 3c590 10MB card, but the same 3c59x driver works with 100MB 3c595 amd 5c905.