Operating System - VMware
1832532 Members
7952 Online
110043 Solutions
New Discussion

Query: ESX Fails to boot after update to 8.0.3

 
AndyBH
Visitor

ESX Fails to boot after update to 8.0.3

We have 6x DL360 Hosts with Alletra 6000 storage.

Every attempt to update to 8..0.3 fails whether performed by the dHCI update process or manually. 

Host reboots showing Version 8.0.3 in the console but the boot never completes.

Its stalls at a screen showing :-

hpp loaded succesfully

activating: restore-paths

 

From there, the host is locked up until reset from the ILO console.

The host will reboot OK the next time but any updates have been rolled back and we are stuck at version 8.0.2

 

Any ideas ? 

 

Thanks, 

Andy     

4 REPLIES 4
Rajaram02
HPE Pro

Re: ESX Fails to boot after update to 8.0.3

Hello Andy,

      How was the manual patching performed ?
Pls follow below steps

To list the available Image Profiles for an ESXi patch
esxcli software sources profile list -d /vmfs/volumes/datastorename/VMware-ESXi-8.0U3-24022510-depot.zip

Output will be the profile name

To install/update a specific Image Profile, run the following command with the Image Profile name:
esxcli software profile update -d /vmfs/volumesdatastorename/VMware-ESXi-8.0U3-24022510-depot.zip
 -p ESXi-8.0U3-24022510-standard



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
AndyBH
Visitor

Re: ESX Fails to boot after update to 8.0.3

@Rajaram02 To say "manual" is perhaps overstating - I meany by using VMware baselines in VCenter to identify and install updates rather than using the DHCI Plugin 'one click update' option.

I have an open case currently (been open since 4th July) so woulkd rather take guidance on that ticket than "go rogue" for now but will refer back to this if I continue to get no progress with the ticket.

 

Thanks, 

 

Andy

Rajaram02
HPE Pro

Re: ESX Fails to boot after update to 8.0.3

HPE Alletra dHCI  provide one click patching or update.
If the one click fails and revert to original esxi version
We may need to check the logs and isolate the issue.
This will be performed on the ticket . 



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
support_s
System Recommended

Query: ESX Fails to boot after update to 8.0.3

Hello,

 

Let us know if you were able to resolve the issue.

 

If you have no further query, and you are satisfied with the answer then kindly mark the topic as Solved so that it is helpful for all community members.

 

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

 

Thank you for being a HPE valuable community member.


Accept or Kudo