HPE Community
ProLiant Servers (ML,DL,SL)
1854907 Members
2031 Online
104105 Solutions
New Discussion

Re: DL380 G3 RAID5 has problem with SCSI ID

 
SOLVED
Go to solution
matteo tg
Occasional Contributor

‎03-08-2009 11:20 PM

‎03-08-2009 11:20 PM

DL380 G3 RAID5 has problem with SCSI ID

Hi,

I have problem with RAID5 rebuilding.
DL380g3 has 3 disks of raid5, SCSI ID 0, 1, 2.

SCSI ID2 disk failed, removed SCSI ID2 disk.
and then wait 30 seconds, inserted new disk
at SCSI ID 2.

When i run ACU, newly inserted disk has
different SCSI ID 6.
failed disk still exist.

I want to know what is happening to my DL380 array card.

Thank you.
0 Kudos
Reply
2 REPLIES 2
Cederberg
Honored Contributor

‎03-09-2009 03:37 AM

‎03-09-2009 03:37 AM

Re: DL380 G3 RAID5 has problem with SCSI ID

Hi..

sounds like the device that makes the DL380 G3 have two channels/Ports on the array.. Can't remember what they are called but it's a little bridge on the back of the harddisk cage..

Can't see any other reason why a disk bay would change it's SCSI ID
Reply
KarloChacon
Honored Contributor

‎03-09-2009 08:55 PM

‎03-09-2009 08:55 PM

Solution

Re: DL380 G3 RAID5 has problem with SCSI ID

that's is a corrupted RIS tables (RAID Information Sector) is corrupted most of the time an old firmware for controller causes that issue

I won't make you loss your time
backup and re-create that's it

I usually recommend in case you wanna try

- remove all HDDS and run erase utility
- update firmware for controller
Didn't your momma teach you to say thanks!
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.