Don't boot from HDD

[Ayman Altounji]

Hi all,
I have a Proliant 800 with Pentium Pro 180 and I install a SoftPAQ for this (firmware upgrade). After this operation I can't boot from HDD. When try to boot computer say: "using drive 0 partition 0" for normal boot and "using drive 0 partition 2" for setup (after press F10) and stop. If I try to boot from FDD or CD its ok. With this HDD I can boot on other PC. I have 2 HDD SCSI 2GB and using SCSI controler on board like first boot controler. I try to use a IDE HDD on IDE controller on board after change this to first boot controler and computer do the same. In my opinion real problem is: computer detect right partition to use boot but don't use it. I already make the last BIOS upgrade after this problem start and this don't solve it.

Please send me some information if you have or some older SoftPAQ

Thnk in advance,

Sorin Serban