HPE Proliant ML30 Gen 10 - not possible to use Windows 2019

[Daniel2604]

Hello,

i tried all installation methods (intelligent provisioning, rapid setup, manuell installation)

Windows 2019 gets the message unmountable boot device.

Manuell installation with Windows 2012 R2 and raid driver (s100i) works fine. Upgrade from Windows 2012 R2 to 2019 fails with same message.

Is this server, or the array not 2019 compatible? tried windows 2019 with different images.

greetings daniel

[Suman_1978]

Hi,

You can check the OS and Server compatibility here.

You may also check these articles and see if your server needs an BIOS/Driver update.
https://community.hpe.com/t5/Alliances/Install-Windows-Server-2019-on-HPE-Servers-easier-than-ever/ba-p/7053834
https://community.hpe.com/t5/ProLiant-Servers-ML-DL-SL/Problem-installing-Windows-server-2019-with-Intelligent/td-p/7043562
https://assets.ext.hpe.com/is/content/hpedam/a00049893enw
https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-a00097789en_us

Thank You!
https://support.hpe.com/hpesc/public/home

[Daniel2604]

Hi,

Server and OS compatibility checked. ML30 Gen10 can use Windows 2019.

2. Link tried both methods without success.

3. link tried successfull with clean installation of 2012, but works not with 2019. Inplace upgrade fron 2012 to 2019 also failes.

4. + 5. link doesnt open

In the last week, we change the server hardware to an equal modell. The same problem.

Firmware Update (startet from IP) is installed. I think, its a problem with the raid driver-

My last change for successful installation, is a try, to install windows 2012 with SPP and then upgrade to windows 2019.

but it is really disappointing to invest so much time for a installation of windows 2019.

[ksram]

Hi,

We understand your concern.

We would request you to follow the steps mentioned to install using the Manual method and injecting the Driver.

https://support.hpe.com/hpesc/public/docDisplay?docId=a00036381en_us

Thank you

RamKS