Start up errors

[Ayman Altounji]

Hi,

I am getting the following errors at bios startup,
goes through detection of discs on scsi card then i get -
177-configuration not complete, controller order not set up.

Goes onto scsi controller on board detects dat drive,
then press f1 to continue or f10 key for system partition utilities.
I press f1 and os (SBS 4.5) loads.

Also i have a problem with dat drive wont detect in control panel, is this related to above.

Thanks Declan

[Sunil Jerath]

You need to go to F10 upon reboot and run Systems Configuration within Configure HW. Then save and exit. Also what type DAT drive do you have. You can always call 1-800-OK-Compaq for any support questions.