Problems activating iLO on DL360 G2 server

[itguy12308]

I have a new DL360 G2 server with now OS. I have configured all parameters as I normally do for the iLO by pressing F8 when the server boots up. However, after saving these changes and rebooting the server, the message "Intergrated Lights-Out is disabled" still appears on the screens during the boot process. How do you "enable" iLO on this server? Thanks!

[James ~ Happy Dude]

Hello,

ON the system board, you will see SW1, a set of 6/8 system maintenance Switches.
S1 switch is for iLO security override switch.
By default, its set to OFF, which means the iLO Security is ON.

Turn the SWITCH to ON-> security DISABLED.
F8 & configure iLO !
reboot. then switch the S1 back to default OFF position->enable security.

Regards.

[Doxey C. Kemp]

Okay, thanks, I disabled security and am ready to configure iLo. But when I press F8 I get Array configuration. So how do I get to iLo config?

[Doxey C. Kemp]

Ah, I was waiting too long. Press F8 while it iLo message on screen. Got it.