P408i-a is not displayed in Intelligent provisioning after upgrade to version 3.81.2

[duderoid]

After upgrading Intelligent Provisioning to version 3.81.2,

RAID controller P408i-a is not displayed anymore in the following path: Intelligent Provisioning –> Perform Maintenance –> Intelligent Storage Configuration.

Instead of the controller configuration settings, this message appeared:

"No controllers found..."

But in BIOS, the iLO interface controller is visible and works correctly. Operation system on this server works correctly too after updating Intellegent Provisioning.

[ryanavarisource]

Maybe your S100i is enabled?

From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Storage Options > SATA Controller Options > Embedded SATA Configuration.

Ensure that you are using the correct ACHI or RAID system drivers for your SATA option.

Select a setting.

SATA AHCI Support—Enables the embedded chipset SATA controller for AHCI.

SmartRAID SW RAID Support—Enables the embedded chipset SATA controller for Dynamic SmartRAID RAID.

Save your setting.

[duderoid]

Thanks,

But how it can help if all HDDs are managed by P408i-a not by S100i. And, how I understand, this option reffer only for embedded adapter.

[MV3]

Hello,

By any chance did you get an opportunity to Downgrade the IP to N-1 and check?

Cheers...

[duderoid]

Hello, 

I tried to downgrade IP to version 3.80.3 and It didn't help.

[MV3]

Hello 

Please raise a support case with HPE, This issue will need AHS logs and IP analysis.

Cheers...