HP1910-8G-PoE+ Help with configuration of remote switch please

[Budgie]

The captioned switch is situated on the far side of a wifi bridge with wifi devices landing on trunk ports and carrying tagged traffic.

On the remote switch there is at present only one acess port configured which is receiving vlan traffic for a subnet and all is working as it should with remote pcs getting address from dhcp server and able to access gateway and WAN.  So there are only two ports connected to the switch, one for the wifi device and one for the PCs.

The management port, Port 1  has been given a fixed IP within my management subnet for fixed devices and is Un-tagged on the management Vlan.  My problem is that when I try and connect to the remote switch using browser from an access port on another managed switch on the management subnet with management Vlan I can make a connection and log in but the connection is very slow and drops very frequently.  I am sure I have forgotten something and seek help please.

[drk787]

Hi

Is this your connectivity ?

PC1<-->Switch1<-->WifiBridge1 ((        )) WifiBridge2 <-->Switch2<-->PC2

And are you trying to connect to Swich2 from PC1 and you see that the connection is slow and drops frequently? If yes, there are many thing to check in between, the Wifi signal strength between both the bridges, if there are any faulty patch cords betwenn the devices, if there is an broadcast storm in the network etc.