HPE Community
Web and Unmanaged
1827458 Members
5504 Online
109965 Solutions
New Discussion

Use VLAN for this setup?

 
Nils Rune Hjelle
New Member

‎03-18-2011 05:15 AM - last edited on ‎07-21-2013 10:35 PM by

‎03-18-2011 05:15 AM - last edited on ‎07-21-2013 10:35 PM by

Use VLAN for this setup?

Hello.

I got a SAN which I will connect to three ESX servers through two HP ProCurve V1910. These switches will also contain management traffic to the SAN and ESX servers, as well as management traffic for the switches themselves.

All servers and SAN got double NICs for both iSCSI traffic and management traffic. This is set up with redundancy, so that if one switch fails the system will still be up. The two switches aren't connected to each other.

The SAN got two iSCSI modules where each module got two NICs. On each module there are two subnets (192.168.130.xxx and 192.168.131.xxx).

My question is wether it's recommended, or even needed, to set up VLAN for this setup?

Regards,
Nils Rune

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. - Hp Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.