HPE Community
Operating System - HP-UX
1838250 Members
4639 Online
110125 Solutions
New Discussion

Re: ping delay I cannot figure out

 
SOLVED
Go to solution
ROSS HANSON
Regular Advisor

‎04-08-2008 12:41 PM

‎04-08-2008 12:41 PM

ping delay I cannot figure out

Hello,
I took a rp2470 PA-RISC box and reloaded it with ll.23 V2. It is now set up in it's permanent place and everything seems ok until you ping another box. The ping goes good for 20 to 40 seconds then it can stop for up to a minute.

I have been with our network folks and they too are baffled. We shutdown quenching by performing ndd -set ip... and made the setting for 0 but this did not solve our problem.
Any ideas, thoughts you have will be appreciated!
Ross Hanson
0 Kudos
Reply
1 REPLY 1
rick jones
Honored Contributor

‎04-08-2008 05:44 PM

‎04-08-2008 05:44 PM

Solution

Re: ping delay I cannot figure out

Are you pinging an IP in the local subnet, or are you going through a router? Does the router respond to ICMP Echo Reqeusts (pings)? What is the setting of ip_ire_gw_probe (iirc).

If there is another HP-UX system in the same broadcast domain, does linkloop show the same behaviour?
there is no rest for the wicked yet the virtuous have no pillows
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.