dl 380 gen 10 showing error message while booting the windows 2016

[pmetal]

x:\windows\system32>hpev CQTESS
Error: deleting EV CQTESS


X:\windows\system32>exit /b 0

X:\windows\system32>

it will halt and cannot boot the 2016 server. help me

[Erdogan Temur]

Hi,

update the HPE Intelligent Provisioning to the latest version.

[terry_00]

Hi Sirs,

We have the same problem as the TS.

After numerous restart, we were able to see windows setup but encountered another issue. A pop-up windows shows "Setup was unable to create a new system partition or locate an existing system partition..." then when press Ok, it goes back to the same error x:\windows\system32......

 Aside to Initial Provisioning, we are using the latest version 3.20

Many thanks,

[MV3]

HI

This error is seen on the server during the installation or after the first boot after installation.Reset or Flash the BIOS.

If the BIOS is corrupted, update BIOS firmware to latest version.

If issue is still persists on the server, use different Operating System ISO and Flash or update the HPE Intelligent Provisioning to the latest version..

I work for HPE.

Cheers

[dsshp]

Hi I have exactly same error but with windows server 2019 instalation, IP is latest  3.21 bios is also latest 1.46.

HP please fix this

[Bob_Kelsall]

Have same issue with a DL360 and Win S 2019, problem seems to be generated from script calling wpeinit.exe which ends with

exit /b 0

Windows is helpful here...
C:\WINDOWS\system32>exit /?

Quits the CMD.EXE program (command interpreter) or the current batch
script.

EXIT [/B] [exitCode]

/B specifies to exit the current batch script instead of
CMD.EXE. If executed from outside a batch script, it
will quit CMD.EXE

exitCode specifies a numeric number. if /B is specified, sets
ERRORLEVEL that number. If quitting CMD.EXE, sets the process
exit code with that number.

Has anyone found a workaround? 

[pmetal · Accepted solution]

In the Perform maintenance ... go to BIOS/Platform

1) Inside this ---reset the BIOS and again install the OS

[sinfoni]

thanks to pmetal for this solution. it worked for me !

[CanBEE]

Thanks to pmetal from me too!

[Phil2815]

I had the same error on a Microserver Gen10 Plus. I overwrote the Inteligent Provisioning V3.50 with an older version 3.45 and it worked for me. I could install Windows Server 2019.